4 link_triangular MADE TO ORDER
Production is consistent but slow. OF all the big products this is the lesser produced. We only do about 50 of these a year right now.
FILL OUT ORDER FORM BELOW TO GET ON LIST.
LEADS ARE NOT GUARANTEED ATM, ROUGHLY 1-3 MONTHS OUT. CAN RUSH IF NEED.
This system has and instant center, where most do not. Everything bolts on. Bag behind axle, sleeve bags must be used (may offer them also) Comes with shock mounts (may offer shocks also as well). Lower bars are 1.75". Uppers are 1.5" Very beefy setup. Does not come with notch, but I can offer a 3" c notch shown here for 150 shipped. This setup should lay 27-28" tire at 4" off frame. Must use a rear mounted fuel tank, which I offer a kit for that shown here. Current version will be for GM rear ends 7.5/6 ring gear (s10's and blazers) and most 8.8 Ford that are not extremely off set. Zr2 option has been sent out, awaiting feedback. Uses all custom bushings. FULLY bolts on.
I will also have air tank brackets (that can be used with my inner bed brackets). Also I offer compressor brackets, shown here. Those will be $120 shipped. Frame boxing plates are another item I offer as well. Some are on store page now.
If running anything over 28" tall, I will have to modify the lower bar some. The bags are compressing as far as they can go with this notch. Anything more, the weight would be on compressed bags (should be something I'll address anyway)
Shipping will vary. It will go in 4 boxes. Most initial quotes from PA to states even to UT or CA cost range from 175-250$ depending on location. We can email a final invoice with accurate shipping costs.
COIL VERSIONS (last 4 photos). Last two pics same truck, customer says its the best driving truck he has every owned, which is a lot. We have another coil over frame fully done in our shop (creme frame). The stance on that frame with drivetrain and body is the patina truck with flag in the bed. This is with NO drop spindles, using our coil arms. Another on the road truck with our arms and 4 link for coil just sold for almost 70k.
The finished chassis is using all my parts I offer, control arms, 4 link, swap kit, compressor brackets, air tank brackets, raised bed brackets, rear fuel tank kit. The finished chassis on checkered floor was done in house and has been sold. We can build you a full chassis if you like.
FILL out order form if you want on list. Be sure to fill out what rear end you have.
NOTE: This requires Rear Fuel tank. We do offer a kit for those on the store page. Stock front leaf perches stay.
Be sure you need, want or will use the kit. Restock fee is 25% if we get it back in same condition. Any orders past 60 days we will not accept returns. No international returns.