4.3 Motor Mounts AD-S10 swap
ONLY OFFERING KIT WITHOUT BUSHINGS CURRENTLY $115 SHIPPED.
The top mounts to block are same as SBC. Uses same bushings as SBC and LS with my setup. Main difference is the baseplates. These use a much larger setback baseplate. As always with my mounts, two height settings. you get bushing part number when you order my mounts.
Comes with upper mounts (to block), setback plates, and hardware (minus 6 block mount bolts).
*NO bushings included with this price. Pics are for bushing placement reference. Uses s10 v6 bushing from 1986. Most parts stores carry them, summit or other major distributors also.
Made in USA
You can probably use any stock clamshell block mount and use my setback plate and bushings. However my block mounts set engine higher and setback is built into them. Since there is so much room with the v6 engines it won't matter too much. So if you want just setback plates those would be $50 alone.
As of 2024 the 4.3 setback plates have additional holes to accommodate SBC or LS settings. So what that means, if you decide to upgrade to SBC later, you can no problem. You have everything you need with this kit to run a 4.3 or SBC. You can also buy my LS upper mounts and use these setback plates, if you decide to upgrade to LS. Basically this new setback plate is a multi use plate rather than just a 4.3 only.
NOTE* Can get tight on Pass side bushing. May have to remove shim in control arm or trim part of bushing top.